There are many different factors that need to be considered when you are going to have your floor sanded. These factors need to be considered in order to get the very best result out of a job and they can be the difference between a perfect floor sanding job and ruining a perfectly goof floor. Here are three tips that should be considered and advice to follow to ensure the best job possible.

Checking for Damaged Floor Boards

There are many ways that damaged boards can cause stoppage on a job or even worse, cause damage to the machinery being used when floor sanding. Things such as loose floorboards or nails and tacks sticking out from the floorboards can make the job more difficult or cause irreparable damage to a workmans floor sander. To make sure that this does not happen, any damage spotted on a board should be marked so that they are easily visible and the workmen know to have them fixed, changed or completely removed.

Checking for Gaps in Floor Boards

Gaps in a floor board not only look bad, but can be symptomatic of other problems and to ensure that the best sanding job is done when sanding, the gaps need to be filled appropriately. Similar to the way you would mark the flooring to highlight any damage including nails, holes or scratches, the flooring needs to be marked to highlight places where there are gaps so they can be filled.

Checking the Thickness of Floor Boards

Easily one of the most important tips when floor sanding, checking how thick the floor board is can be a make or break thing. You need to know how thick the flooring to ensure that you do not sand too much off and leave the floorboard too thin. This is especially important if you plan on sanding laminate flooring or flooring that is already finished. The best way to do this is to remove part of the skirting board and measure the edge. You only want to sand off as little as possible to achieve your finish you want and if you follow this tip, youre sure to be left with a great finish.